Furuno FAR-3230S(-BB) Installation Manual page 36

2. WIRING
8) Fasten the two heater elements to the chassis. Fasten the base of the heater
with two M5 screws (supplied) coated with marine sealant supplied. Fasten
the installation materials to each of the cover bolts.
9) Attach the supplied earth label over the earth label attached near the ground-
ing terminal.
Note: If it is necessary to open the
front cover after installing the DE-
ICER kit, remove the power cable
from the locking wire saddle in the
right figure then detach the cover
slowly to prevent damage to the
heater.
14. Re-mount the RF unit then reconnect the connectors for the motor (J803, J840
and J804), the four bolts (see step 4) and the coaxial cable (see step 3). The
torque must be 27.5 N•m.
15. Pass the LAN cable of the antenna cable from
the cable entrance through two locking wire
saddles to the LAN port at the bottom of the RF
unit (J821).
16. Attach appropriate WAGO connector (supplied) to both the antenna cable and the
cable for the sub monitor. Connect the antenna cable and the cable for the sub
monitor to the RF-TB Board as shown below. A terminal opener is provided on the
RF-TB Board.
2-8
M5 screw coated with marine sealant M5 screw coated with marine sealant
Grounding terminal Grounding terminal
M5 screw M5 screw
Fixing Shaft Fixing Shaft
SD Heater SD Heater
Fixing Plate Fixing Plate
Cover Bolt Cover Bolt
Earth label
Remove the power Remove the power
cable from the cable from the
locking wire saddle to locking wire saddle to
open the front cover. open the front cover.
Locking Locking
LAN port LAN port
wire wire
saddles saddles