Advertisement
MOU TI G I STRUCTIO S
⚠
arninge!
It is advisable to have an Öhlins dealer install the shock
absorber/front fork/steering damper.
⚠
arninge!
If working on a raised vehicle, ensure it is securely
supported so that it will not tip.
otee!
1
Before mounting this product clean the vehicle
thoroughly.
otee!
1
When working on this product, always see the Vehicle
Service Manual for vehicle specific procedures and
important data.
1
Put the motorcycle on a workstand so that the
rear wheel barely touches the ground.
2
Loosen and remove the original shock
absorber.
3
Install the Öhlins shock absorber in the same
way as the original shock absorbers. The fill
screw pointing towards the rear.
otee!
1
Lower the vehicle so that the suspension is slightly
compressed before tightening the screws.
✋
Cautione!
Ensure that all screws are tightened to the correct
torque and that nothing fouls or restricts movement of
the shock absorber/front fork/steering damper when the
suspension is fully compressed or extended.
2
Advertisement
