Ohlins HA 192 Owner's Manual

F1
R1
R2
Bike on a stand. Bike on the ground.
Setup data
Lenght 444 mm
Stroke 127,5 mm
Rebound adjustment 22 clicks
Compression adjustment 15 clicks
High speed comp. adj 2 1/2 turns
Preload 10 mm
Free sag, rear 35 mm
Ride height, rear 100 mm
Front fork position 0 mm
(top surface above triple clamp)
Front fork adjustment std.
Recommended fork springs std.
Öhlins Racing AB, Box 722, S-194 27 Upplands Väsby, Sweden.
Phone +46 8 590 025 00. Fax +46 8 590 025 80. www.ohlins.com
F2
R3
Bike with rider on.
Checking sag and ride height
Front suspension
F1. Bike on a stand with the
suspension fully extended = ............
F2. Bike on the ground without rider = ............
F3. Bike on the ground with rider = ............
F1 - F2 = ............
Free sag
F1 - F3 = ............
Ride height
Rear suspension
R1. Bike on a stand with the
suspension fully extended = ............
R2. Bike on the ground without rider = ........... .
R3. Bike on the ground with rider = ............
R1 - R2 = ............
Free sag
R1 - R3 = ............
Ride height
NOTE!
If ride height is higher than recommended,
softer spring/springs must be used.
If ride height is lower than recommended,
harder spring/springs must be used.
Contact your Öhlins dealer for advice.
F3
Mounting instructions Öhlins shock absorber kit
© Öhlins Racing AB. All rights reserved. Any reprinting or unauthorized use without the
written permission of Öhlins Racing AB is prohibited. Printed in Sweden.
Owners Manual
HA 192 for Husqvarna CR 250
Adjusters
Your Öhlins shock absorber type 46 PRC features the
High speed
followinging adjusters:
compression
Compression damping:
Adjustments are made on top of the reservoir.
Low speed
Low speed adjustments: Slotted centre screw
compression
High speed adjustments: Hexagon screw.
Rebound damping
Adjuster whell on the piston shaft above the end bracket.
Spring preload
Adjustment made by screws om cylinder house.
Spring preload
Use C-spanner.
When delivered the Öhlins shock absorber is dialed to
recommended settings for the specific brand and make
of the motorcycle. If you have changed the setting check
Rebound
like this:
adjustment
The adjusters have a normal right hand tread. Turn
clockvise to fully closed. Turn counter clockvise to open
and count the clicks until you reach the recommended
number of clicks.
Do not use to much force, delicate sealing
surfaces can be damaged. Do use fingers only.