Temperature Considerations - Siemens AS 100 Instruction Manual

Accessory Mounting
Extension Tab
Screw Sensor into threaded hole of tab,
and fasten onto device being monitored.
Notes:
• If welding, weld must be a continuous bead. Tacking does not provide
sufficient acoustical coupling.
• Do not arc weld on equipent connected to a SITRANS AS 100. Remove the
SITRANS AS 100 or disconnect electrically to avoid current flowing through
the sensor.
• If gluing, use Loctite 326 adhesive, or equivalent. Follow manufacturer's
instructions to ensure proper adhesion.

Temperature Considerations

Warning: Temperature at Sensor must not exceed minimum or
maximum ratings.
Ensure adequate isolation from hot
surfaces by providing additional
spacing.
for standard Temperature
Note:
range model, maximum
temperature is 80 °C.
*maximum range dependent on model.
Page 8
< 80 ºC
>80 ºC
SITRANS AS 100 – INSTRUCTION MANUAL
Mounting Disc
Screw Sensor into disc, after welding or
bonding disc onto device being monitored.
Tab acts as heat sink.
Note: If the flange temperature is 100 °C
and the ambient temperature is 20 °C,
the Sensor temperature at the
electronics is below the maximum
rating.
20 ºC
100 ºC
65 ºC
7ML19985DM02