Tips:
To ensure handwriting accuracy, use the pen provided together
●
with the interactive panel rather a finger to perform calibration.
Calibration errors may cause failures in the touch functions of the
●
interactive panel. In that case, please perform calibration again.
Tap ESC on the keyboard during the calibration process to cease
●
calibration.
The calibration interface varies between different software versions.
●
Please follow instructions provided on the actual interface.
OPS Installation
Insert the OPS into the slot and fasten it with two M4 screws respectively
on the top and bottom. Both the standard OPS and non-standard OPS
are supported.
Standard OPS
NOTE:
The OPS does not support hot-plugging. Please insert or pull out the OPS after the
interactive panel is disconnected from the power supply.
Select Signal Channel
Press Source to display the list of signal sources. Press ▲/▼ to select an
option and press OK to enter the sub-menu.
If no signal source is available, press MENU. In the displayed list, set
signal Search to On. After 30 seconds, the interactive panel automatically
detects signal sources and switches to a signal source. The signal source
searching scope and priority sequence is: PC, HDMI1, HDMI2, HDMI3,
OPC-PC, Component, AV.
Non-standard OPS
17