Power off
Standby status: When the interactive panel is in running status, press
●
Power or
on the remote controller. The interactive panel enters in
standby status. When the OPS is in running status, Press PC Power on
the front panel. The OPS enters in standby status (for all-in-one models
only).
Power off: Turn off the rocker switch at the bottom of the interactive panel
●
(next to the power port) or pull out the power plug to switch off the
interactive panel completely.
For all-in-one models, turn off the OPS before powering off the interactive
●
panel.
NOTE:
If the PowerKey Turn On PC is enabled, you do not need to press PC Power to
control the OPS during the power-on and power-off processes.
Status of the power indicator is as follows:
Power Indicator
Software Installation
Recommended configuration:
●
- CPU: Inter (R) Core i3 2.27GHz or AMD CPU with equivalent performance
- Memory: 1GB
- Hard drive: 1GB
- Graphics card: supports DirectX 9 or above
If the interactive panel is equipped with the latest version of handwriting
●
software in the PC before being delivered, please skip the step.
HID drive-free function only applies to Vista, Windows 7 or higher
●
versions (to realise the functions of multi-touch etc.). The touch LED display
with Windows XP version will install/run the software for normal use.
Step 1: Insert the official USB cable into the USB ports of the computer and
touch LED display.
Step 2: Insert the official software installation disk into the computer.
No light
Red
Green
12
Status
Powered off
Standby
Powered on