Lighting And Operating; Failure To Ignite; Extinguishing - NESTOR MARTIN H11 Installation And Operating Instructions Manual

FAILURE TO IGNITE

The system will fail to ignite if there is insufficient or too much oil in the burner or because of an electrical power
failure.
When no oil (or an excess of oil) is present, check the setting of the carburator. Also, its arming lever and supply
line should be examined for faults.
Do not repeatedly attempt to ignite a burner if it fails to light. If no cause is found in the burner, a suitable
qualified technician should be consulted.
Before lighting
- Check that the valve on the tank is open,
- Check that the setting lever on the float chamber is in the upward position.
LIGHTING
A.
Open the front door only slightly.
B. Turn the control knob to position 1 (minimum) - this will allow fuel to enter the burner/s. As soon as fuel
enters the burner (after about one minute) the fuel must be ignited.
C. To ignite the fuel use either a small piece of fire lighter, a taper or a well lighter match. The lighted item must
be placed at the base of the pot
D.
Close the front door after about 2-3 minutes (depending on the draft).
Warning: The door may be left ajar only during lighting. The door must stay closed throughout the normal
operation of the appliance. As the appliance requires a good chimney draught, it is imperative to allow the
chimney to be thoroughly warmed before increasing the distributor control knob settings.
With a chimney which is new or has not been used for a long period, it is adviseable to leave the appliance at
minimum setting for up to 1 hour.
In cases of an already warm chimney or recently used appliance, only 10-15 minutes will be required.
Note: If on lighting from cold a large smokey flame develops and persists and does not clear, the oil supply should
be isolated to extinguish the fire. The chimney should then be examined for blockage or other means of poor flue
draught.

EXTINGUISHING

1. Turn the control knob to position 0.
2. Shut the reservoir tap.

3. LIGHTING AND OPERATING

C07100DC023
58