Locating Fibers - Fluke SimpliFiber Pro User Manual

SimpliFiber Pro Meter and Test Kits
Users Manual

Locating Fibers

FindFiber mode helps you quickly identify link connections at
patch panels.
To use FindFiber mode:
1 Connect the meter and a SimpliFiber source or one or
more FindFiber sources to the links as shown in Figure 6.
2 Turn on the meter and the source or FindFiber sources.
• If you are using a SimpliFiber source, press
source.
• To change the number transmitted by a FindFiber
source, turn the source off, hold down the power key
for about 4 seconds; then release the key when the
desired LED turns on.
M
3 On the meter, press
4 The meter indicates connectivity as shown in Table 4:
20
I
on the
until FindFiber ™ appears.
Table 4. FindFiber Source Numbers
Source Connected
SimpliFiber Pro multimode source
SimpliFiber Pro singlemode source
1310/1550 nm
SimpliFiber Pro singlemode source
1490/1625 nm
FindFiber source
No continuity or incompatible
source connected
In power or loss mode, ID blinks if the meter is
connected to a FindFiber source or a source in ID
mode.
ID Number on
the Meter
1
2
3
Number indicated by
the source's LED
Note