Error Conditions - Motorola GP68 Service Manual

GP68 Portable Radios Service Manual
The slave radio displays the following message
5
(Figure 4-4) while it is being programmed.
Figure 4-4 .
NOTE
If battery level is low, the slave radio will dis-
play , and you will need to replace or
recharge the battery before repeating the pro-
cedure.
Error Message
Err.01 Incompatible software options error.
Err.02
a. The cloning cable connection is not
properly connected or slave radio is
not turned on.
b. Communication between the two ra-
dios is disrupted during the cloning
process.
Err.03
Err.04 No Programmed Channels Error
March, 1997
Table 4-1Cloning Error Messages
Problem
Timeout error
Master radio checksum error
When cloning is completed, both radios will reset auto-
6
matically.
7 Disconnect radios from the cloning cable. They are now
ready for operation.

Error Conditions

An error may occur when cloning a radio. When this hap-
pens, an error message is displayed. Table 4-1 lists the
causes and the possible solutions for each error message.
Cloning from the master radio to the slave radio cannot be
performed.
a. Check the cloning cable connection and also verify that
the slave radio is turned on.
b. Check the cloning connection and all other connections.
Although the master radio may still function, it should be
serviced by a dealer.
a. If this occurs on the slave radio, repeat cloning procedure.
If it persist, the radio must be serviced by a dealer.
b. If this occurs on the master radio, the radio must be ser-
viced by a dealer.
6881086C09-O
Radio Programming Information
Option Board Setup Mode
Solution
4-3