Removing The Interface Module; Installing And Removing Sfp, Sfp+, And Qsfp+ Transceiver Modules And Cables - HPE LSWM124XG2Q User Manual

Removing the interface module

CAUTION:
• Before you remove the interface module, remove the cable
from it to avoid cable damage.
• If you are not to install a new interface module, install a filler
panel in the slot to prevent dust and ensure good ventilation in
the device.
To remove the interface module:
1. Prepare an anti-static bag.
2. Press the latch to release the ejector lever.
3. Rotate outward the ejector lever, as shown by callout 1 in
4.
4. Pull the interface module slowly out of the interface module slot,
as shown by callout 2 in
5. Place the removed interface module in the anti-static bag.
Figure 4 Removing the interface module
Installing and removing SFP, SFP+, and QSFP+
transceiver modules and cables
For information about installing and removing SFP/SFP+ transceiver
modules and SFP+ cables, see Pluggable SFP/SFP+/XFP
Transceiver Modules Installation Guide.
For information about installing and removing QSFP+ transceiver
modules and cables, see QSFP+ Transceiver Modules/Cables
Installation Guide.
Figure 4.
11
Figure