Canceling A Print Job; Printing In Continuous Mode - Pitney Bowes J640 Operator's Handbook Manual

J640 Operator's Handbook

Canceling a Print Job

To cancel the current print job, hold down the trigger until the
LED stops blinking and displays solid green. The batch is
canceled and the data is lost. To resume printing, you must
download the batch again.
Printing in Continuous Mode ––––––––––––––––––––––––––––––––
In this mode, a format and data packet with a specific quantity
of labels are sent to the printer. The labels print in one
continuous strip.
To print in Continuous Mode:
1. Load the supplies for non-peel mode. See Chapter 2,
"Loading Ribbon and Supplies."
2. The host sends the label data to the printer.
3. After the data packet is downloaded, the LED is solid
amber to indicate the printer is ready to print and labels will
print automatically.
4. After all the labels in the batch print, remove the label strip
from the printer.
DO NOT jerk or pull labels strongly against the printhead. This
may cause a label jam.
The operator can switch between the continuous and
on-demand modes by holding the trigger for about two
seconds, until the LED changes to the appropriate color for the
mode desired. Once changed, the operator must then turn the
printer off and on to reload the formats. If the LED is green, it
is in the on-demand mode. If it is amber, it is in the continuous
mode.
3-2