En Repair And Maintenance; Diaphragm Replacement; Pushing Rod; S Service Och Underhåll - Orion 22206 User Manual

Air operated diaphragm pumps
Hide thumbs Also See for 22206:
Table of Contents

Advertisement

EN Repair and maintenance

Before any service is done to the pump,
disconnect air supply!

Diaphragm replacement

1. Close fluid valves
2. Drain the fluid inside the pump.
3. Remove the directional valve, be careful not to
damage the seals.
4. Remove the diaphragm cap screws, NOTE: to
tighten these screws you must use a torque
wrench calibrated to(see table on page 9)
5. Remove the cover by gently pulling back.
6. Remove the used diaphragm and place the
new one in the correct position.
Reassemble components.

Pushing rod

Looking at the fluid inlet, remove the side cover as
shown in the figure, following the procedure
"diaphragm replacement".
Once the shaft is visible, use the following
procedure:
1. Remove the shaft from its housing by pulling it
from one end. The Teflon® sleeve is threaded
into the body. To remove, use snap ring pliers
in the two holes as indicated in the figure.
2. Once the cap has been removed, remove the
quad ring inside the pump body.
3. Replace the kit following the correct order in
the assembly drawing.
Reassemble the pump in reverse order.
Diaphragm pumps_EN_SE_1d
S Service och underhåll
Innan något arbete utförs på pumpen måste
lufttillförseln kopplas bort!

Byte av membran

1. Stäng vätskeventilerna.
2. Tappa ur vätskan från pumpen.
3. Ta bort riktningsventilen, se till att inte
packningarna skadas.
4. Ta bort skruvarna som håller
membrankåporna. (OBS, när dessa
återmonteras måste en momentnyckel
användas med värde enligt tabell på sid. 9)
5. Drag försiktigt loss kåporna.
6. Ta bort de gamla membranen och montera
de nya i rätt position.
Återmontera i omvänd ordning

Membran axel

Med vätskeinloppet emot dig, ta loss den högra
pumpsidan enligt instruktioner i " Byte av
membran".
När axeln är synlig gör enligt följande:
1. Ta loss axeln genom att dra i dess ände.
Teflon® hylsan är gängad i kroppen och tass
lättast bort med hjälp av en låsringstång enligt
figuren.
2. När hylsan är borta, ta loss quad-ringen i
pumpkroppen.
3. Montera de nya delarna enligt figuren nedan.
Montera ihop pumpen.
.
9

Advertisement

Table of Contents
loading

Table of Contents