Teledyne EV71YC1MCL2010-BA0 User Manual page 25


Sensor Mode (SensorMode) : Defines the number of pixels and their size.
versatile models.
This command is available in the CommCam "Image Format Control" section :
 Read function (ASCII): "r smod";
Returned by the camera : Integer from 0 to 3
 Write function (ASCII): "w smod" <value> :

"0" : 4096 pixels, 5x5µm

"1" : 2048 pixels, 10x10µm

"2" : 1024 pixels, 10x10µm

"3" : 512 pixels, 10x10µm

"4" : 4096 pixels, 5x10µm

Reverse Reading (X) (ReverseReading) : Allows to output the line in the Reverse-X direction.
This value is available in the CommCam "Image Format Control" section :

Read function : "r revr";
Return by the Camera : 0 or 1 (enabled/disabled)

Write function : "w revr <value>";
 "0" : Disabled.
 "1" : Enables the reverse reading out

Output mode (OutputMode) : Set the CameraLink Output mode.
This command is available in the CommCam "Image Format Control" section :
 Read function (ASCII): "r mode";
Returned by the camera : Output mode from 0 to 10 (see table below).
 Write function (ASCII): "w mode" <value> :
detailed in the table below :

Interlaced Mode (InterlacedMode) : Set the Tap Interlaced (odd/even) Mode.
This command is available in the CommCam "Image Format Control" section :
 Read function (ASCII): "r itrl";

Return by the Camera : 0 or 1 (enabled/disabled)
 Write function (ASCII): "w itrl" <value> :
 "0" : Disabled.
 "1" : Interlaced (odd/even) Taps enabled (not for single Tap or 10 Taps Mode)
U M UNIIQA+ M
SER ANUAL ONOCHROME
– R J – 05/2017
EV
Only available for
P | 25
A G E