JVC XL-R2010BK Service Manual page 9

Removing the CD mechanism assembly
Prior to performing the following procedure, remove
the top cover and the fitting.
(Remove the front panel assembly is easy to work.)
1. Disconnect the card wire from connector CN615 and
CN616 on the main board from above.
2. Remove the three screws H
mechanism assembly.
Removing the CD-R/RW mechanism
assembly (See Fig.16)
Prior to performing the following procedure, remove
the top cover and the fitting.
(Remove the front panel assembly is easy to work)
1. Disconnect the wire from connector CN721 and the
card wires from CN722 and CN723 on the main
board from above.
2. Remove the three screws I attaching the CD-R/RW
mechanism assembly.
Removing the rear panel (See Fig.17)
Prior to performing the following procedure, remove
the top cover.
1. Remove the three screws J and the eight screws K
on the back of the body.
Removing the main board (See Fig.18)
Prior to performing the following procedure, remove
the top cover, the front panel assembly, the CD
mechanism assembly, the CD-R/RW mechanism
assembly and the rear panel.
1. Remove the four screws L attaching the main board.
(See Fig.15)
H
attaching the CD
CD mechanism assembly
CD mechanism assembly
Rear panel
J
L
Main board
CN616
H
Fig.15
Main board
CN721
CN722
CN723
I
Fig.16
K
K
J
Fig.17
L
Main board
Fig.18
XL-R2010BK
CN615
H
CD-R/RW mechanism
assembly
I
I
CD-R/RW mechanism
assembly
K
J
Rear panel
L
Chassis base
1-9