Advertisement
Removing the traverse mechanism assembly
Remove the clamper base assembly and tray.
Reference: The traverse mechanism assembly can
be removed without removal of the
mechanism board.
1. If the traverse mechanism assembly is lowered and it is
located out of the PLAY position, turn the idle gear in the
arrow-marked direction so that the hole in the part f of the
tray gear meets the hole on the loading base assembly.
(Set the traverse mechanism assembly at the PLAY
position.)
2. Remove the three screws B attaching the traverse
mechanism assembly and then remove the traverse
mechanism assembly upwards from the front side.
3. At the same time, remove the spring from the groove of the
CH. base assembly in the part g of the traverse
mechanism assembly.
Note: When reinstalling the traverse mechanism
assembly:
Check to see if the spring is properly
engaged with groove of the CH. base
assembly in the part g of the traverse
mechanism assembly.
After making sure that the three insulators of
the traverse mechanism assembly are
properly set on the bosses of the loading
base assembly's guide, fasten them with the
screws.
(See Figs. 6 to 9)
mechanism
assembly
B
Traverse
Part g
B
Fig. 6
Loading base assembly
Fig. 7
Spring
Part g
Fig. 8
Spring
Groove of CH. base assembly
Fig. 9
XL-R2010BK
B
Idle gear
Tray gear
Tray gear
Part f
1-13
Advertisement
