Advertisement
XL-R2010BK
Removing the front panel assembly
Prior to performing the following procedure, remove
the top cover and both fittings of the CD mechanism
section and the CD-R/RW mechanism section.
1.
Disconnect the card wires from connector CN501,
CN841 and the wires from CN711 and CN712 on the
main board from above.
2.
Remove the screw C and the screw D attaching the
headphone board and the mic board on the top of
the body.
3.
Remove the four screws E attaching the right and
left foot at the bottom.
4.
Remove the two screws F
attaching the front panel assembly at the bottom.
5.
Disengage the joint e on the bottom and the joints f
on each side of the body to release the front panel
assembly from the chassis base using a slotted
screwdriver. Then remove the front panel assembly
toward the front.
Headphone board
1-8
(See Fig.10 to 14)
and the screw G
Front panel assembly
C
Joint f
Fig.14
Main board
CN712
CN711
C
Headphone board
Front panel assembly
(Bottom)
Foot
E
Front panel assembly
(Bottom)
F
Front panel assembly
Front panel assembly
Joint f
CN841
D
Mic board
CN501
Fig.10
Foot
E
Fig.11
Joint e
G
Fig.12
D
Mic board
CN801
Chassis base
Fig.13
F
Advertisement
