Advertisement
Removing the pickup (See Figs. 11 to 14)
Remove the clamper base assembly and tray.
Remove the traverse mechanism assembly.
Reference: The pickup can be removed without
removal of the mechanism board.
Note: Before disconnecting the flexible wire coming
from the pickup from the connector, be sure to
solder its shorting round.
If the flexible wire is connected without
soldering, it may cause breakdown of the
pickup.
1. Solder the shorting round of the flexible wire
connected with the mechanism board from the back
of the traverse mechanism assembly.
2. Disconnect the flexible wire from the connector
CN601 on the mechanism board.
3. Turn the idle gear in the arrow-marked direction from
the top of the traverse mechanism assembly so that
the pickup assembly is shifted to the reverse side of
the turn table assembly.
Move the pickup assembly until the part j of the rack
plate in the lower part of the pickup assembly comes
out of the CH. base assembly.
4. Remove the two screws D attaching the shaft of the
pickup assembly. Next, disengage the part k from
the CH. base assembly and then remove the pickup
assembly together with the shaft.
5. Pull the shaft out of the pickup.
6. Remove the two screws E attaching the rack plate
from the pickup.
7. Remove the screw F attaching the P.S. spring from
the pickup.
Flexible wire
Fig. 11
CH. base
assembly
Turn table assembly
Part j of
rack plate
Idle gear
Fig. 12
Pickup assembly
D
Fig. 13
Shaft
Part j
Rack plate
E
Fig. 14
XL-R2010BK
Shorting round
CN601 on
mechanism
board
Pickup assembly
Part k
CH. base
assembly
D
Pickup
P.S. spring
F
1-15
Advertisement
