Shure GLXD4R Instructions Manual page 7

GLXD4R Half-Rack Wireless Receiver
③ Power Switch
Turns the transmitter on/off.
④ TA4M Input Jack
Connects to a 4-Pin mini connector (TA4F) microphone or instrument cable.
⑤ Micro USB Charging Port
Connect to USB battery charger.
⑥ Link Button
• Press and hold within 5 seconds of power-on to manually link with receiver
• Press momentarily to activate Remote ID function
⑦ Battery Compartment
Holds 1 Shure rechargeable battery.
⑧ Microphone Cartridge
GLXD-2 transmitter models are available with the following cartridge types:
SM58, Beta 58, SM86, Beta 87A.
4 3
1
off on
7
Transmitter Status LED
LED is green during normal operation.
LED color or flashing indicates a change in transmitter status as shown in
the following table:
Color State
Flashing (slow)
Flashing (fast)
Green
Flashes 3
times
On
Red
Flashing
Red/Green Flashing
Amber Flashing
2017/05/18
2
GLXD2
on
5
6
6
7
1
Status
transmitter attempting relink with receiver
unlinked transmitter searching for receiver
indicates locked transmitter when power
switch is pressed
battery life < 1 hour
battery life < 30 minutes
remote ID active
battery error, replace battery
Wearing the Bodypack Transmitter
Clip the transmitter to a belt or slide a guitar strap through the transmitter clip
as shown.
For best results, the belt should be pressed against the base of the clip.
8
Wearing the Headworn Microphone
• Position the headworn microphone 13 mm (1/2 in.) from the corner of
your mouth.
• Position lavalier and headworn microphones so that clothing, jewelry, or
2
other items do not bump or rub against the microphone.
3
5
Correct Microphone Placement
• Hold the microphone within 12 inches from the sound source.
• For a warmer sound with increased bass presence, move the microphone
closer to the sound source.
• Do not cover grille with hand.
Shure Incorporated
13 mm
(.5 in.)
7/20