Power connector port and micro serial port are assembled as one single component to connect on the tablet system board.
NOTE:
Malfunction of either component requires to remove both power connector port and micro serial port.
Installing micro serial port and power connector port
1
Insert the power connector port and micro serial port into the slot on the chassis.
2
Align the metal bracket that secures the ports on the chassis.
3
Replace the screws (5) to secure the micro serial port and power connector port to the chassis.
4
Align the rubber bracket and push to slide in the channel .
NOTE:
Rubber bracket ensures to secure the micro serial port cable from damage.
5
Insert the micro serial port cable into the connector.
6
Release the latch to secure the micro serial port cable to the system board.
7
Align the power connector cable and replace the screw (1) to secure the power connector port on the system board.
NOTE:
Ensure to replace the screw, which enables the power connector port to charge the battery.
8
Install the:
a
Display assembly
b
Battery
9
Follow the procedure in
Front camera
Removing front camera
1
Follow the procedure in
2
Remove the:
a
Battery
b
Display assembly
3
To remove the front camera:
a
Place the back side of system on a flat surface.
b Locate the front camera.
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
27