Usb-Port Assembly; Removing The Usb-Port Assembly; Installing The Usb-Port Assembly - Dell Latitude 7230 Service Manual
Rugged extreme tablet
Hide thumbs
Also See for Latitude 7230:
- Setup and specifications (29 pages) ,
- User manual (9 pages) ,
- Manual (19 pages)
Table of Contents
Advertisement
USB-port assembly
Removing the USB-port assembly
Prerequisites
1. Follow the procedure in
2. Remove the stylus.
3. Remove the
handle
(for the models shipped with a handle).
4. Remove the batteries.
5. Remove the
back-cover
Steps
NOTE:
For models shipped with an USB connector in the expansion bay at the top side of the tablet.
1. Remove the two screws (M2x3) that secure the USB-FPC bracket to the system board.
2. Remove the USB-FPC bracket away from the system board.
3. Disconnect the USB FPC from the USB daughter-board.
4. Remove the four screws (M2x5) that secure the USB-port cover to the USB-port bezel .
5. Remove the USB-port cover from the tablet.
6. Remove the two screws (M2x3) that secure the USB-port bezel in place.
7. Remove the USB-port bezel away from the tablet.
8. Remove the two screws (M2x3) that secure the USB-port assembly in place.
9. Remove the USB-port assembly from the tablet.
Installing the USB-port assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Steps
NOTE:
For models shipped with an expansion bay at the top side of the tablet.
1. Align the screw holes on the USB-port assembly with the screw holes on the tablet.
2. Replace the two screws (M2x3) to secure the USB-port assembly in place.
3. Align the screw holes on the rugged USB-port bezel with the screw holes on the tablet.
4. Replace the two screws (M2x3) to secure the USB-port bezel in place.
5. Align the screw holes on the USB-port cover with the screw holes on the USB-port bezel.
6. Replace the four screws (M2x5) to secure the USB-port cover to the USB-port bezel.
7. Connect the USB FPC to the connector on the USB daughter-board.
8. Align the screw holes on the USB-FPC bracket with the screw holes on the system board.
9. Replace the two screws (M2x3) to secure the USB-FPC bracket to the system board.
Next steps
1. Install the
back-cover
2. Install the batteries.
3. Install the
handle
(for models shipped with handle).
4. Install the stylus.
5. Follow the procedure in
before working inside your
assembly.
assembly.
after working inside your
tablet.
tablet.
Removing and installing components
43
Hide quick links:
Advertisement
Table of Contents
