Installing Display Assembly - Dell Latitude 12 7212 Owner's Manual

NOTE: DO NOT remove any cable or adhesive tape from the display panel, unless you are replacing the cables
separately.

Installing display assembly

1 Place the system chassis on a plane surface.
2 Place the bottom edge of the display assembly inside the bottom edge of the rear chassis.
3 Rest the display assembly by less than 90° angle.
NOTE: Use a support to attain the required angle.
4 Connect the touch cable, function keys cable, and LVDS cable to the connector on the system board.
5 Release the latch to secure the cables to the respective connecting ports.
NOTE: Make sure to insert the cable under the clips, if not, the system may not display video after reassembling.
6 Paste the adhesive tapes to secure the connected slots.
NOTE: Ensure to secure the adhesive tapes, to protect the display assembly from electrostatic discharge damage.
7 Align the display assembly on the tablet chassis and press the edges to snap-in.
NOTE:
• Ensure that the Window button on the display assembly aligns with the docking pogo pins on the system board
chassis.
• Press the edges starting from Windows button clockwise until they snap-in evenly from all sides. Ensure to hear a
click sound when the display assembly is aligned in correct position.
8 Flip the system so that the battery is at top view.
NOTE: Ensure to place the system in a flat surface.
9 Replace the (19) screws to secure the display assembly to the tablet.
NOTE: DO NOT wind the screws too much, to avoid damage the screws thread.
Removing and installing components 17