Checking The Mac Address - Pioneer VSX 1020 Operating Instructions Manual

11 The system and the other setup
IP Address
The IP address to be entered must be defined
within the following ranges. If the IP address
defined is beyond the following ranges, you
cannot play back audio files stored on
components on the network or listen to
Internet radio stations.
Class A: 10.0.0.1 to 10.255.255.254
Class B: 172.16.0.1 to 172.31.255.254
Class C: 192.168.0.1 to 192.168.255.254
Subnet Mask
In case an xDSL modem or a terminal adapter
is directly connected to this receiver, enter the
subnet mask provided by your ISP on paper. In
most of the cases, enter 255.255.255.0.
Default Gateway
In case a gateway (router) is connected to this
receiver, enter the corresponding IP address.
Primary DNS Server/Secondary DNS Server
In case there is only one DNS server address
provided by your ISP on paper, enter 'Primary
DNS Server'. In case there are more than two
DNS server addresses, enter 'Secondary DNS
Server' in the other DNS server address field.
Proxy Hostname/Proxy Port
This setting is required when you connect this
receiver to the Internet via a proxy server. Enter
the IP address of your proxy server in the
'Proxy Hostname' field. Also, enter the port
number of your proxy server in the 'Proxy Port'
field.
Tip
• Press / or the numeric buttons to enter
alphanumeric characters. To delete
alphanumeric characters entered one at a
time, press CLEAR.
Note
1 The IP address determined by the Auto IP function is 169.254.X.X. You cannot listen to a internet radio station if the
IP address is set for the Auto IP function.
104
En
1 Select 'IP Address, Proxy' from the
Network Setup menu.
2 Select the DHCP setting you want.
When you select ON, the network is
automatically set up, and you do not need to
follow Steps 3. Proceed with Step 4.
If there is no DHCP server on the network and
you select ON, this receiver will use its own
Auto IP function to determine the IP address.
3 Enter the IP Address, Subnet Mask,
Default Gateway, Primary DNS Server and
Secondary DNS Server.
Press / to select a number and / to
move the cursor.
4 Select 'OFF' or 'ON' for the Enable Proxy
Server setting to deactivate or activate the
proxy server.
In case you select 'OFF', proceed with Step 7.
In case you select 'ON', on the other hand,
proceed with Step 5.
5 Enter the address of your proxy server or
the domain name.
6 Enter the port number of your proxy
server.
7 Select 'OK' to confirm the IP Address/
Proxy setup.

Checking the MAC address

You can check the MAC address.
• Select 'Information' from the Network
Setup menu.
1