Processor Unit - Furuno FMD-3200 Installation Manual

2.1

Processor Unit

2.1.1 How to connect cables to terminals on the processor unit
Use screws (M3x6, supplied) to
attach the wiring plate 1 and wir-
ing plate 2 assy to the processor
unit. Connect the cables shown
below to the connectors at the
front of the processor unit. After
the connection, bind cables to
the appropriate fixing metal with
the cable ties (supplied).
For the cables from the monitor unit (type: DVI-D/D SLINK5M/10M (MU-190 only),
DSUB9P-X2-L5/10M) and ground wire, connect them to the processor unit directly
(without fixing to a wiring plate). Tighten the fixing screws on these connectors to pre-
vent disconnection from the processor unit.
Note: Connect the cables so that they do not interfere with the opening or closing of
the DVD tray.
LAN1
HUB-3000
(DTI-C5E350 VCV
cable)
Power cable
(IEC60320-C13-
L5M cable)
HUB-100/MC-3000S
(FR-FTPC-CY cable,
within 50m)
USB4
For USB printer
Cables connected at the wiring plate 1
• USB cables from the control units
• Printer cable
• LAN cable (type: DTI-C5E350 VCV) from the HUB-3000
• LAN cable (type: FR-FTPC-CY) from the HUB-100/MC-3000S
Cables connected at wiring plate 2 assy
• Power cable (Type: IEC60320-C13-L5M)
• LAN cable to the LAN3 port
COM2 DVI3
Cable clamp
LAN2
USB1
RCU-024/026
(TS-20-071-1 cable)
LAN3
Not used.
USB2/3
Optional control unit
RCU-024/026
(TS-20-071-1 cable)
Monitor unit
(DVI3: DVI-D/D S-LINK cable
or DVI-BNCX5-L2000 cable,
COM2: DSUB9P-X2-L cable)
DVI2
(DVI2: DVI-D/D S-LINK cable
or DVI-BNCX5-L2000 cable)
Ground wire
(IV-2sq.,
local supply)
COM1 DVI1
Monitor unit
(DVI1: DVI-D/D S-LINK cable,
COM1: DSUB9P-X2-L cable or DSUB9P-X2-A-L cable)
2. WIRING
Monitor unit
2-3