Troubleshooting - X2 Digital Wireless Systems XDR-95x User Manual

Digital uhf wireless system
Table of Contents

Advertisement

Troubleshooting

Issue
No sound.
Intermittent sound or distorted
sound.
Lack of range.
Power
Make certain that the transmitter and receiver are receiving sufficient power. The receiver requires 9V DC at 500mA. The handheld
transmitter required 3V DC via two alkaline AA batteries. The bodypack transmitter requires 9V DC via alkaline 9V battery. Check the
battery status indicator on the transmitter and replace if necessary.
Signal Source
Make certain that the source is operating as desired by checking source power, signal levels and connections. If necessary, bypass
digital wireless transmission and check the source directly.
Cables
Make certain that all connections and cables are in working order.
RF
Turn all known transmitters off. Check to see if the red RF LED on the receiver's front panel is lit. If it is not lit, then the receiver is not
detecting the presence of RF signal on the currently selected channel. If it is lit, then the receiver is detecting the presence of unknown
RF signal. Check to see if any of the green Receiver LEDs are lit. If any are lit, then the receiver is detecting the presence of another X2
transmitter set to the same channel. Locate this unit and either turn it off or switch channels. If none of the green Receiver LEDs are lit,
then the receiver is detecting confirmed RF signal from a source other than an
X2 transmitter. Change the channel and repeat these steps to locate a clear channel.
Cause
System not turned on. Source malfunction. Im-
proper connection or improper channel selection.
Expired battery.
Source malfunction. Improper connection. Multiple
transmitters are set to the same operating channel.
Transmitter has gone out of range. Transmitting
through metal wall. Unknown source of RF in local
area.
Improper or lack of antenna connection. Multiple
transmitters are set to the same operating channel.
Unknown source of RF in local area.
See Solution...
Power, Signal Source, Cables or RF
Signal Source, Cables or RF
RF
14

Advertisement

Table of Contents
loading

Table of Contents