Handheld Lcd Interface; Operation - Edit Channel; Operation - Edit Transmitter Power; Operation - Set Lock Function - X2 Digital Wireless Systems XDR-95x User Manual

Digital uhf wireless system

Table of Contents

Handheld LCD Interface

Press Set once to put the transmitter in Channel Select mode ("ch. 5" will continuously blink). Press Select once to choose this mode

("Ch." will stay solid and the "5" will blink). Press Select again to choose the desired channel. Once you've made your final selection,

press Set once to put the transmitter on the new channel ("Ch. 5" will blink twice giving you visual confirmation of your selection and will

automatically return to Main View).

Press Set twice to put the transmitter in RF Power edit mode ("TX PWR" and the current value will continuously blink). Press Select

once to choose this mode ("TX PWR" will stay solid and the current value will continuously blink). Press Select again to choose the

desired power setting (HI or LOW). Once you've made your final selection, press Set once to put the transmitter on the new power set-

ting ("TX PWR" and the new value will blink twice giving you visual confirmation of your selection and will automatically return to Main

View).

Press Set three times to put the transmitter in Lock edit mode ("ON or OFF" and the lock symbol will continuously blink). Press Select

once to choose this mode (the lock symbol will stay solid and "ON or OFF" will continuously blink). Press Select again to choose the

desired state. Once you've made your final selection, press Set once to put the transmitter in the new state. While in the locked state,

no changes can be made to the transmitter. Additionally, the transmitter cannot be powered down until it is returned back to standard

operation. Should the transmitter be left in this state until the batteries expire, simply replace the batteries and press the power button.

The transmitter will power up and function as previously programmed while remaining in a locked state.

NOTE: Any attempt to make changes to the transmitter will trigger the word "Lock" to blink twice and then display Locked Operation

readout.

NOTE: To regain control of a locked transmitter, press and hold both the Set and Select buttons for three seconds. This calls up the

Lock edit mode.

Press Set four times to put the transmitter in Name edit mode ("Name" will continuously blink). Press Select once to choose this mode

(the first character will blink). Press Select again to choose the desired character. Press Set to move to the next position and continue

this process until you've completed entering in the desired name. After making your final character selection in the fourth position,

press Set to complete the naming process. The display will now show its new name in the Main View.

Press Set five times to put the transmitter in Mute edit mode ("MUTE" will continuously blink). Press Select once to choose this mode

(the MUTE symbol will stay solid and "ON or OFF" will continuously blink). Press Select again to choose the desired state. Once

you've made your final selection, press Set once to put the transmitter in the new state. While in Mute mode, the Select button will

promptly cause the audio signal to mute on or off. Should the transmitter be left in this state until the batteries expire, simply replace

the batteries and press the power button. The transmitter will power up and function as previously programmed.

Table of Contents