Preparing the Transmitter for Use
Battery Installation
Step 1:
Press and slide the battery door open and connect the 9V battery as shown in figure 14.
Step 2:
Insert the battery into the compartment and close the battery door then secure the door by sliding shut as shown in figure 15.
Battery Life
Fresh Alkaline batteries should last about ~5.5 hours in the XDT4. NiCad rechargeable batteries will only last about 3.5 hours. Standard
batteries are not recommended. THE BATTERY HOUR DISPLAY WILL ONLY BE ACCURATE FOR ALKALINE BATTERIES. The bat-
tery life is calculated inside the each component and displayed in 1 hour increments. Upon power up the battery info will take about one
minute to stabilize, the battery gauge is then accurate within + or - 15 min. You may use batteries
until they are completely drained without affecting the performance of the unit in any way.
FIGURE 14
FIGURE 15
12