Remote Direct Function; Editing Remote Control Button Names - Pioneer VSX-59TXi Elite Operating Instructions Manual

Controlling other equipment
08
Note
• If you see Failed (or OK! doesn't appear) on the
touch panel, or OK! is displayed, but you find that the
command wasn't learned, try teaching the command
again, but vary the distance (closer or farther)
between the remote controls. Some signals may be
stronger than others and require more distance (a
projector's remote signal, for example).
• There may be certain remote signals that can't be
programmed correctly.
• The remote control has a limited memory. If you see
Memory Full appear in the display, use the PRESET
RECALL feature in Recalling preset codes on page 67
to overwrite any programmed buttons that you aren't
using. This will free up memory to program additional
remote signals.

Remote Direct function

• Default setting: All inputs – ON
On the default setting, when you press an input select
button (DVD/LD, DVR/VCR1, etc.), both the receiver
input source and the remote control change to the
selected function.
When an input select button is set to OFF, pressing that
button changes the function of the remote control only.
This can be useful when you want to operate one
component without interrupting playback of another.
1 Press DIRECT FUNCTION on the remote setup
menu.
70
En
SETUP 1/3
CALIBRATE
PRESET RECALL
LEARNING
MULTI OPERATION
DIRECT FUNCTION
2 Choose the setting of an input by pressing the
ON/OFF button on the touch screen.
Each press switches between ON and OFF.
DIRECT FUNCTION
DVD/LD : ON
TV/DVD : ON
SAT : ON
• Use the (cursor up/down) buttons to scroll
through the component options.
3 Press OK to confirm the settings.

Editing remote control button names

You can rename the buttons on the remote control menu
screens for different input sources (such as DVD/LD or
SAT). You may want to do this if you taught the remote
control a new command in Programming signals from
other remote controls above, but the command doesn't
correspond with the button name.
1 Press KEY LABEL on the remote setup menu.
SETUP
CLOCK DISPLAY : AM/PM
CLOCK SETTING
BEEP :
TIMEOUT
KEY LABEL
2 From the 'Select Function' screen, select the input
source menu that contains the button you want to
rename.
For example, press DVD/LD if you taught the DVD/LD
remote screen a new command from your DVD player.
Select Function
KEY LABEL
DVD/LD
TV/DVD
OK
2/3
SAT
CANCEL