Reducing The Level Of An Analog Signal; Adjusting The Delay Of A Soundtrack; Watching Video And Audio Sources Independently - Pioneer VSX-59TXi Elite Operating Instructions Manual

Using other functions
09
Reducing the level of an analog
signal
The input attenuator lowers the input level of an analog
signal when it's too strong. You can use this if you find
the that the OVER indicator is lights often, or you can
hear distortion in the sound.
• From the remote control receiver menu, press
INPUT ATT to switch the input attenuator on or off.
You may need to press
first before reaching the receiver menu screen shown
below (use the
the previous/next menu screen).
Note
• The attenuator isn't available with digital sources, or
when using Stream Direct modes 2 or 3.

Adjusting the delay of a soundtrack

Some monitors have a slight delay when showing video,
so the soundtrack will be slightly out of sync with the
picture. By adding a bit of delay, you can adjust the sound
to match the presentation of the video.
1 Press OPTION repeatedly until SOUND DELAY
shows in the display.
With the remote, you may need to press
Home menu (
screen shown below (use the
soft keys to go to the previous/next menu screen).
76
En
on the Home menu (
RECEIVER
(cursor left/right) soft keys to go to
3/4
RECEIVER
TV
RECEIVER
CONT
SB CH
INPUT
MODE
SPEAKER INPUT
A/B ATT
VIDEO DISPLAY
SELECT DIMMER
TAPE2
STATUS
MONITOR
RECEIVER
) first before reaching the receiver menu
(cursor left/right)
2/4
RECEIVER
TV
RECEIVER
CONT
MIDNIGHT DIGITAL NR
TONE LOUDNESS
– +
OPTION
– +
CH LEVEL
ACOUSTIC
CAL. MIDNIGHT TONE
PHONES SP SYSTEM SIGNAL
A/B SELECT
2 Use the (OPTION) +/– buttons to adjust the
amount of delay.
The delay can be adjusted from 0.0–6.0 frames (in 0.1
frame steps).
)
3 Press ENTER to confirm.
Note
• When listening to an analog source, you can't use
sound delay when Stream Direct is on.
• One second is equal to 30 frames of NTSC format
video, and 25 frames of PAL.
Watching video and audio sources
independently
You can listen to a sound source and select a different
video source on your TV.
• While listening to a source, press VIDEO SELECT
to select the video source you want to watch.
With the remote, you may need to press
Home menu (
screen shown below (use the
soft keys to go to the previous/next menu screen).
on the
ACOUSTIC
CAL. MIDNIGHT TONE
PHONES SP SYSTEM SIGNAL
A/B SELECT
Press repeatedly to cycle through the possible video
sources. You can select DVD/LD, TV, SAT, VIDEO, DVR/
VCR1, VCR2, VCR3 or OFF (no video signal).
TUNER
OPTION DIGITAL NR CLASS STATION
VIDEO INPUT
VIDEO TAPE2 STREAM SETUP
SELECT MONITOR DIRECT MIC DIGITAL IN
S-VIDEO
RECEIVER
) first before reaching the receiver menu
(cursor left/right)
RECEIVER 3/4
TV
RECEIVER
CONT
SB CH
INPUT
MODE
SPEAKER INPUT
A/B ATT
VIDEO DISPLAY
SELECT DIMMER
TAPE2
STATUS
MONITOR
TUNER
OPTION DIGITAL NR CLASS STATION
VIDEO INPUT
VIDEO TAPE2 STREAM SETUP
SELECT MONITOR DIRECT MIC DIGITAL IN
S-VIDEO
MULTI ROOM & SOURCE
SB CH
MODE CONTROL ON/OFF
VIDEO L AUDIO R
on the
MULTI ROOM & SOURCE
SB CH
MODE CONTROL ON/OFF
VIDEO L AUDIO R