Pioneer VSX-59TXi Elite Operating Instructions Manual page 62

The Surround Setup menu
07
Setting the Acoustic Calibration EQ manually
Before manually adjusting the Acoustic Calibration EQ,
we recommend copying the ALL CH ADJ or the FRONT
CH ALIGN settings from the Auto setup above (or from
Introduction to home theater on page 39) to one of the
custom settings. Instead of just a flat EQ curve, this will
give you a reference point from which to start (see
Copying your Acoustic Calibration EQ settings below for
how to do this).
1 Select 'Acoustic Cal EQ' then press ENTER.
2 Select 'Manual' then press ENTER.
3 Select CUSTOM1 or CUSTOM2 then press ENTER.
4 Select the channel you want, adjust the
frequency curve to your liking, then move to the
next speaker.
Use the (cursor left/right) hard keys to select the
channel, then ENTER to select it.
Use the (cursor left/right) hard keys to select the
frequency and
EQ. When you're finished, press ENTER to move to the
next channel.
62
En
2.Surround Setup
[ Check ]
[ 1.Speaker Systems ]
[ 2.Channel Level ]
[ 3.Speaker Distance ]
[ 4.Acoustic Cal EQ ]
[ 5.X-Curve ]
[Return]
2. 4. Acoustic Cal EQ
[Data Copy]
[Manual]
CUSTOM1 , CUSTOM2
[Auto]
ALL ADJ & FRONT ALIGN
[Professional]
[Return]
2.4. Acoustic Cal EQ
Manual
[ CUSTOM1 ]
A[ CUSTOM2 ]
[Return]
2.4. Acoustic Cal EQ
Manual
Target Curve : CUSTOM1
Channel [L•SMALL]
TRIM
[Return]
(cursor up/down) to boost or cut the
Tip
• Changing the frequency curve of one channel too
drastically will affect the overall balance. If the
speaker balance seems uneven, you can raise or
lower channel levels using test tones with the TRIM
feature. Use (cursor right) to move to the far right
side of the OSD, then use
raise or lower the channel level for the current
speaker.
5 When you're done, press
select 'Return' then press ENTER to finish.
Note
• If the message OVER !! appears on-screen, it means
the frequency curve may result in distortion from the
speaker. Adjust the frequency curve accordingly.
Copying your Acoustic Calibration EQ settings
If you want to manually adjust the Acoustic Calibration
EQ (see Setting the Acoustic Calibration EQ manually
above), we recommend copying the ALL CH ADJ or the
FRONT CH ALIGN settings from the Auto setup above
(or from Introduction to home theater on page 39) to one
of the custom settings. Instead of just a flat EQ curve, this
will give you a reference point from which to start.
1 Select 'Acoustic Cal EQ' then press ENTER.
2.Surround Setup
[ Check ]
[ 1.Speaker Systems ]
[ 2.Channel Level ]
[ 3.Speaker Distance ]
[ 4.Acoustic Cal EQ
[ 5.X-Curve ]
[Return]
2 Select 'Data Copy' then press ENTER.
2. 4. Acoustic Cal EQ
[Data Copy]
[Manual]
CUSTOM1 , CUSTOM2
[Auto]
ALL ADJ & FRONT ALIGN
[Professional]
[Return]
(cursor up/down) to
(cursor down) to
]