Switching The Speaker Impedance; Checking Your System Settings - Pioneer VSX-59TXi Elite Operating Instructions Manual

Using other functions
09

Switching the speaker impedance

• Default setting: Speaker 6Ω Ω Ω Ω
We recommend using speakers of 6Ω to 16Ω with this
system, but it is possible to switch the impedance setting
if you plan to use speakers with a lower impedance rating
(for example, less than 6Ω).
• With the receiver in standby, press
ON while holding down the OPTION – button.
STANDBY/ON
OFF ON
INPUT SELECTOR
ACOUSTIC
TONE OPTION
CAL. MIDNIGHT
PHONES SP SYSTEM SIGNAL VIDEO
A/B SELECT SELECT
Each time you do this, you switch between the
impedance settings:
• Speaker 4Ω Ω Ω Ω – Use this setting if your speakers are
rated lower than 6Ω.
• Speaker 6Ω Ω Ω Ω – Use this setting if your speakers are
rated 6Ω or more.
Note
• If you select Speaker 4Ω Ω Ω Ω above, the Stream Direct
setting is fixed at SD:1 NORMAL (see Using the
Stream Direct mode on page 47).
78
En
STANDBY/
STANDBY
VIDEO
CD-R/
DVD/LD TV/DVD SAT VIDEO DVR/VCR1 VCR2 VCR3 CD TAPE1/MD
TUNER SB CH
DIGITAL NR CLASS STATION MODE
VIDEO INPUT
TAPE2 STREAM SETUP
MONITOR DIRECT MIC DIGITAL IN
S-VIDEO VIDEO

Checking your system settings

Use the status display screen to check the various
settings you've made for features such as sound delay,
digital noise reduction, and high-sampling.
1 From the remote control receiver menu, press
STATUS to check the system settings.
You may need to press
first before reaching the receiver menu screen shown
below (use the
the previous/next menu screen).
AUDIO
TUNER P
MULTI ROOM & SOURCE
CONTROL ON/OFF
These appear on both the OSD and the front panel
display.
L AUDIO R
The front panel display shows each of the following
settings for two seconds each:
Surround back speaker/
Virtual back speaker
Acoustic calibration EQ
Digital noise reduction
Midnight
Loudness
Tone
Note
• If the Stream Direct mode is switched on, some
settings above will show OFF, even though they are
switched on.
2 When you're finished, press STATUS again to
switch off the display.
on the Home menu (
RECEIVER
(cursor left/right) soft keys to go to
RECEIVER 3/4
TV
RECEIVER
CONT
SB CH
INPUT
MODE
SPEAKER INPUT
A/B ATT
VIDEO DISPLAY
SELECT DIMMER
TAPE2
STATUS
MONITOR
SB CH MODE : OFF
ACOUS. CAL EQ : ALL ADJ
DIGITAL NR : OFF
MIDNIGHT : ON
LOUDNESS : OFF
TONE CONTROL : OFF
VIDEO SELECT : DVD/LD
DUAL MONO : CH1
SOUND DELAY : 0.0frame
HI-BIT : OFF
HI-SAMPLING : OFF
REAL PHANTOM : OFF
Video select
Dual mono
Sound delay
Hi-bit
High-sampling
Real phantom
)