Auto-Off Time Setting - Trans instruments WalkLAB HP 9010 Operation Manual

Clr
- CLEAR SAVED MEMORY
This setting will clear all saved memory in the unit.
1 Press the
ENTER
blinking.
2. Press the SELECT
between yes yes and no
yes yes
3. Choose Yes to clear, press the
confirm.
4 . Press the
SELECT
Unt
- TEMPERATURE UNIT OF MEASUREMENT
This setting allows you to set the unit of measurement
for temperature between Celcius and Fahrenheit.
Factory preset is in Celcius.
1. Press the
ENTER
blinking.
2. Press the
SELECT
between C C C C and F F F F
3. Press the
ENTER
4. Press the
SELECT
Avto off
This setting allow you set the time to automatically
shutoff the unit to power save. This feature is good if
you want the meter to make prolong measurement or
continuous display.
1. Press the ENTER
blinking.
2. Press the SELECT
no,15 no 15minutes, 30
no no 15 15
3. Select no no will disable auto-shutoff feature.
no no
4. Press the ENTER
5. Press the
SELECT
key to set; display will show No
key up or down to choose
no no no.
key up for next setting.
key to set; display will show C C C C
key up or down to choose
key to confirm.
key up for next setting.

- AUTO-OFF TIME SETTING

key to set; display will show 15
key up or down to scroll between
30 minutes or 60 60 minutes.
30 30 60 60
key to confirm.
key up for next setting.
No No No
ENTER key to
15 15 15
6
no
CLr
Memory
EXIT
ENTER SETUP
SELECT
C
°C
UNt
EXIT
ENTER SETUP
SELECT
Avto
15
EXIT SETUP
ENTER
SELECT