Trans instruments WalkLAB HP 9010 Operation Manual page 5

6 SETTING UP THE UNIT:
6.1 Before you begin using the unit, it is important to define your
measuring requirements.
accurately on the condition of sample that is measured.
6.2 While the unit is switched ON, press the SELECT button once and the
Button Keys Legend will show
6.3 Press the SETUP
6.4 Display will show
6.5 Press the SELECT button up to move to next setting or down to the
previous setting parameter displayed on screen.
6.6 After setting, meter will retain the info until you reset them.
6.7 Below are the description for each setting parameter:
* Anytime during setup, press
Alc
- AUTO LOCK SETTING
Auto-lock feature allows the meter to automatically
sense a stabilized reading and locks the endpoint
reading. Factory preset is Yes
1. Press the ENTER
blinking.
2. Press the SELECT
yes yes
between yes yes
3. Press the
ENTER
4. Press the
SELECT
tr
- DATA TRANSMISSION TO PC
(Note: will not appear if no data saved)
This setting allows you to download saved memory
data to PC via the RS232 connector & CD software
kit (connector & software kit sold separately).
1. Download the software and run on PC.
2. Follow the CD instructions to setup software and
PC connection with RS232 connector.
3. Press the
ENTER
tr tr tr tr
between
4. When display return to
Check the PC for the transferred file.
5. Press the
SELECT
key to enter setup mode.
blinking, indicating you are in setup mode.
SETUP
Yes Yes. Yes
key to set; display will show
key up or down to choose
no no
and no no
key to confirm.
key up for next setting.
key and display will alternate
out out out out
and , indicate transfer in progress.
tr tr tr tr
key up for next setting.
This will allow the unit to display
SETUP appear.
EXIT
to cancel the setting.
, transfer completed.
4
Auto Lock
Yes
Yes Yes
Yes Yes
EXIT
SELECT
tr
EXIT
SELECT
ALc
SETUP
ENTER
ENTER SETUP