Assembly Of The Hard Catcher; Attaching The Hard Catcher; Assembly Of The Side Discharge Chute; Recoil Starter Handle Holder - Gardenline 56979 User Manual

Assembly

Assembly of the Hard Catcher

The hard catcher (43) is supplied in 2 sections.
Locate the top half of the catcher on top of the
bottom half and interlock them together by
aligning the clips on the top half of the catcher
into the raised ridge around the bottom half of the
catcher, then push the halves together until they
click into place. (Fig L)

Attaching the Hard Catcher

1. Lift the rear discharge guard (16) in order to
position the assembled hard catcher (43).
NOTE: Do NOT ever start the lawn mower if the
rear discharge guard does not fully return to the
close position if the catcher is not fitted.
2. Apply the hard catcher (43) by aligning the
catcher attachment bar (44) on the catcher over
the catcher attachment bracket (15) centrally so
the catcher is sitting evenly.
3. Release the rear discharge guard (16) to secure
the hard catcher (43) into place. (Fig M)
NOTE: Always empty the catcher before it has
reached maximum capacity, otherwise it will
decrease the performance of the lawn mower.
TIP: Do not leave grass clippings in the catcher
for extended periods of time.

Assembly of the Side Discharge Chute

WARNING: Ensure the engine is NOT operating when fitting the side
discharge chute (20).
Do not operate or have the engine running when the side ejector cover is
opened and the discharge chute is not fitted.
NOTE: The side discharge chute (20) is used to distribute grass clippings
from the side of the mower while the mower is in use. To use this function,
the hard catcher (43) is NOT required to be assembled on the lawn mower.
22
e-mail: help@powertoolsupport.com
MODEL No.: DM53E3-D196 • 10/2017 • 56979
196cc 4 Stroke Petrol Lawn Mower
L.
M.
AFTER SALES SUPPORT
1800 909 909
(toll free)
196cc 4 Stroke Petrol Lawn Mower
1. Raise the side ejector cover (21) to be able to
position the side discharge chute (20) onto the
side of the deck of the lawn mower. (Fig N)
2. Place the side discharge chute (20) into position
on the side of the deck, by aligning the 2 top
tabs on the side discharge chute (20) with
the bars on each side at the top of the side
ejector cover (21), and then place the 2 top tabs
underneath the bars to secure (Fig O). Release
the side ejector cover (20). (Fig P)
3. To remove the side discharge chute (20), raise the side ejector cover (21),
and remove the side discharge chute (20). Lower / release the side ejector
cover (21).
O.
NOTE: For the
best performance
in "side discharge
chute" mode,
insert the
mulching block
(39).
Slide tabs under bars

Recoil Starter Handle holder

When not using the recoil starter (23), it can be pulled up to the recoil starter
handle holder (47). By looping the pull cord through the holder, the recoil
handle can sit securely in the recoil starter handle holder (47) for when not
in use.
AFTER SALES SUPPORT
1800 909 909
(toll free)
Assembly
N.
Raise ejector cover
P.
e-mail: help@powertoolsupport.com
MODEL No.: DM53E3-D196 • 10/2017 • 56979
23