Assembly Of The Catcher; Installing/Removing The Catcher - Gardenline SLM462 User Manual

AUS
Assembly
A3. Choose a required hole from the 3 holes on the upper handle (4)
which will increase or decrease the handle height. Align the hole in
upper handle (4) with the hole on the lower handle (5). (See Fig. A3)
4) Insert the outer fastening lever (with large washer) for the upper
handle (4), into the aligned holes on the external side of the upper
handles (4), then apply the inner fastening knob (with small washer)
for the upper handle (4) on the internal side of the upper handle (4)
to clamp the lever.
5) Push the outer fastening lever into the down position, and use the
locking knob to secure the handles in place by turning in a clockwise
direction. (See Fig. A4, A5)
A3
2. ASSEMBLY OF THE CATCHER (See Fig. B)
The catcher (17) is supplied in 2 sections. Locate
the top half of the catcher on top of the bottom
half and interlock them together by aligning the
clips on the top half of the catcher into the raised
ridge around the bottom half of the catcher, then
push the halves together until they click into
place.
3. INSTALLING/REMOVING THE CATCHER (See Fig. C1- C3)
NOTE: Do NOT ever start the lawn mower if the rear discharge guard
(7) does not fully return to the closed position if the catcher (17) is not fitted.
WARNING: Ensure the mower is switched off before installing or
removing the catcher.
1) Lift the rear discharge guard (7) in order to position the assembled
22
e-mail: info.aldi@positecgroup.com
MODEL No.: SLM462 • 03/2019 63158
A4
196cc 4 Stroke Petrol Lawn Mower
A5
B
40
AFTER SALES SUPPORT
AUS
1300 889 028
(toll free)