Assembly Of The Hard Catcher; Attaching The Hard Catcher; Cutting Height Adjustment - Gardenline 60751 User Manual

Assembly

Assembly of the Hard Catcher

WARNING. Ensure the motor is off and
not operating when undertaking this task.
1. The hard catcher (7) is supplied in two sections.
Locate the top half on top of the bottom half and
interlock them together by aligning the clips on
the top half of the catcher into the raised ridge
around the bottom half of the catcher, then push
the halves together until they click into place. (Fig H)

Attaching the Hard Catcher

WARNING. Ensure the motor is off and not operating when
undertaking this task.
1. Lift the rear discharge guard (10) in order to position the catcher. (Fig I)
NOTE: DO NOT ever start the mower if the rear discharge guard (10) does
not fully return to the close position if the catcher is not fitted.
2. Apply the hard catcher (7) by aligning the catcher attachment bar (12) on
the catcher over the catcher attachment bracket (11) centrally so the catcher
is sitting evenly. (Fig J)
3. Release the rear discharge guard (10) to secure
the catcher in place. (Fig K)
NOTE: Always empty the hard catcher (7) before
it has reached maximum capacity, otherwise it
will decrease the performance of the mower.
TIP: Do not leave clippings in the catcher for
extended periods.
J.
18
e-mail: help@powertoolsupport.com
MODEL: №. DM46P-DO160 • 09/2018 • 60751
4 Stroke Petrol Lawn Mower
H.
I.
K.
AFTER SALES SUPPORT
1800 909 909
(toll free)
4 Stroke Petrol Lawn Mower

Cutting Height Adjustment

WARNING: Stop the engine and unplug
the spark plug before any repairs or
maintenance operations.
This mower has one lever to easily adjust the
cutting height. There are 7 height settings.
1. Stop the engine of the lawn mower before
making a height adjustment. To decrease the
cutting height pull the height adjustment lever
(28) out and move it up a notch, towards the handlebar. (Fig L)
2. To increase the cutting height pull the height adjustment lever (28)
out and move it down a notch, towards the engine. (Fig L)
3. After adjustment, ensure the lever is fully
located in the selected notch.
NOTE: If you are unsure of which cutting height to use, begin with a high
setting and trial a small section of lawn, then check the appearance of the
lawn. Then readjust if necessary.
AFTER SALES SUPPORT
1800 909 909
(toll free)
Assembly
L.
LOWER
RAISE
e-mail: help@powertoolsupport.com
MODEL: №. DM46P-DO160 • 09/2018 • 60751
19