Switching The Hdmi Output; Checking Your System Settings; Resetting The System - Pioneer Elite SC-07 Operating Instructions Manual

13 Using other functions

Switching the HDMI output

SC-07 only
Set which terminal to use when outputting video and
audio signals from the HDMI output terminals (HDMI
OUT1, HDMI OUT2 or HDMI OUT ALL).
The HDMI OUT1 terminal is compatible with the HDMI
control function.
TV TV
CH
• Set the operation selector switch to RCV, then press
HDMI OUT.
Please wait a while when Please wait ... is displayed.
The output switches among HDMI OUT1, HDMI OUT2
and HDMI OUT ALL each time the button is pressed.

Checking your system settings

Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
TV TV
CH
TVCONTROL
1 Set the operation selector switch to RCV, then press
STATUS to check the system settings.
These appear on the front panel display.
The front panel display shows each of the following
settings for two seconds each:
Note
1 • Synchronized amp mode on page 91 is canceled when the HDMI output is switched. If you wish to use the synchronized amp mode, switch
to HDMI OUT1, then select the synchronized amp mode on the flat panel TV using the flat panel TV's remote control.
• When the power is turned off then back on after switching the HDMI output, the input is set to a setting between HDMI1 and HDMI3, or BD.
2 If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on.
100
En
SIGNAL SEL SLEEP DIMMER AUDIO
SR+ SBch MCACC
DISP
SOURCE SOURCE
A.ATT A.ATT GENRE HDMI OUT
RCV RCV
CH
D.ACCESS CLASS
VOL
VOL
ENTER
CLR
CATEGORY RETURN
HOME
MENU
TUNE
iPod CTRL
SOURCE SOURCE
STATUS STATUS PHASE CTRL CH LEVEL
RCV RCV
THX MPX MEMORY
VOL
VOL
AUTO/ STEREO/
DIRECT A.L.C. STANDARD ADV SURR
PGM
BD MENU
2
Input source
↓
Surround Back Processing
↓
MCACC preset
↓
ZONE 2 input
↓
ZONE 3 input
↓
HDMI Control
↓
HDMI OUT
2 When you're finished, press STATUS again to
switch off the display.

Resetting the system

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to OFF.
1 Switch the receiver into standby.
2 While holding down HOME MENU on the front
panel, press  STANDBY/ON.
The display shows RESET  NO .
3 Press ENTER on the front panel.
Select 'RESET' using /, then press ENTER on
4
the front panel.
The display shows RESET? OK.
5 Press ENTER to confirm.
OK appears in the display to indicate that the receiver
1
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.