Model 1 Cutting Machine - Thames & Kosmos AIR Plus Water Power Experiment Manual

AIR+WATER power |
Cutting
Machine
Assembly Notes
1. The gears should mesh well with each other in order
to operate smoothly. We encourage you to tinker and
improve the design to make the models run smoothly.
2. Note that the sprockets must be aligned in order for
the chain to operate smoothly.
3. Cut Tube A and Tube B to get tubes of the following
lengths for this model. (The same tubes will be used
for all models.)
Tube A : 9.5 cm x 1, 30 cm x 1, 37 cm x 1, 44 cm x 1
Tube B : 25 cm x 1, 35 cm x 1
1
5
9

MODEL 1 Cutting Machine

Parts Needed
x 1
x 1
x 1
x 1
x 2
x 3
(Note: Gears shown
here may differ slightly
from those in the kit.)
2
6
10
12
x 1
x 2
x 1
x 2
x 16 x 1
x 1
x 2 x 36
x 2
1
Tube A
3
7
11
x 1
x 4
x 2 x 2
x 1
x 1 x 1
x 2
x 1
x 1
x 1 x 1
x 4
2
3
Tube B
4
8