Thames & Kosmos AIR Plus Water Power Experiment Manual page 42

AIR+WATER power |
Antique Car
Assembly Notes
1. Unscrew the original cap of the pressurized
air+water tank before starting the assembly. The
original cap will not be used in this model.
2. The gears should mesh well with each other in order
for the chain to operate smoothly.
3. Note that the sprockets must be aligned so that
the chain can operate smoothly.
4. Cut Tube A to get tubes of the following lengths for
this model.
Tube A : 9.5 cm x 1, 30 cm x 1, 44 cm x 1
1
5
9
MODEL 14 Antique Rocket Car
Parts Needed
x 1
x 1
x 1
x 3
2
6
10
40
x 1
x 2
x 1
x 2
x 1
x 1
x 2
x 1
x 1 x 4
x 2
x 1 x 2
x 2
x 2
1
3
7
11
x 1
x 1
x 1
x 2
x 2
x 2
x 1
x 1
x 3
x 1
x20
x47
x 2
x 5
(Note: Gears shown
2
here may differ slightly
from those in the kit.)
4
Tube A
3
4
8
12