Model 15 Propeller Aircraft - Thames & Kosmos AIR Plus Water Power Experiment Manual

MODEL 15 Propeller Aircraft

Propeller
Aircraft
Assembly Notes
1. Unscrew the original cap of the pressurized air+water tank be-
fore starting the assembly. The original cap will not be used in
this model.
2.
The parts shown here on the model must be tightly fixed to-
gether so that the propeller can rotate.
3. The gears should mesh well with each other in order for the
chain to operate smoothly.
4. Note that the sprockets must be aligned so that the chain can
operate smoothly.
5. Leave a 1 mm gap between the axle lock and the long frame so
that the wheel can turn smoothly.
6. Cut Tube A to get tubes of the following lengths.
Tube A : 9.5 cm x 1, 30 cm x 1, 44 cm x 1
1
4
| AIR+WATER power
Parts Needed
x 1
x 1
x 1 x 1
x 1
x 1
x 2
x 1
x 1
x 3
2
5
43
x 1
x 2
x 2
x 2
x 2
x 1
x 2
x 2 x 4 x 4
x 2 x 2 x 2
x20
x 2
x 2
1 2
4 5
6
x 1
x 1
x 2
x 2
x 1
x 1
x31
x 4
3
6
Tube A
3