Setup For Pv - Tektronix OI1125 Instruction Manual

Setup For PV

OI1125 E/O Transmitter Instruction Manual
Table 11: Test equipment (cont.)
Description Minimum requirements
Optical cable, PM FC-APC Single mode, 18 cm
Optical cable, PM FC-APC Single mode, 2 m
Optical cable FC-APC to FC/PC, Single mode, 2 m
6 dB, 50 W, SMA
Attenuator, electrical
Torque wrench 5/16-in, 7-10 in-lb. (8 mm, 79 to
112 N-cm)
1. Before beginning these procedures, photocopy the test record on page 57 and
use it to record the performance test results.
2. Install the laser safety interlock on the back of the instrument, or short pins 1
and 2 of the DB-25 remote port connector. (See Figure 9 on page 16.)
Performance Verification
Example product
Tektronix part number
174-4664-00
Tektronix part number
174-4725-00
Tektronix part number
174-4727-00
Tektronix part number
015-1001-00
Pasternack Enterprises
PE 5011-1
33