Configuration Example - HP FlexFabric 7900 Series Configuration Manual

Step
2. Apply the ACL to
an SNMP
community,
group, or user.

Configuration example

Network requirements
Configure the device in
Figure 16 Network diagram
Configuration procedure
# Create an ACL to permit packets sourced from Host A and Host B.
<Sysname> system-view
[Sysname] acl number 2000 match-order config
[Sysname-acl-basic-2000] rule 1 permit source 10.110.100.52 0
Command
•
SNMP community:
snmp-agent community { read | write } [ simple | cipher ]
community-name [ mib-view view-name ] [ acl acl-number ] *
•
SNMPv1/v2c group:
snmp-agent group { v1 | v2c } group-name [ read-view
view-name ] [ write-view view-name ] [ notify-view
view-name ] [ acl acl-number ] *
•
SNMPv3 group:
snmp-agent group v3 group-name [ authentication |
privacy ] [ read-view view-name ] [ write-view view-name ]
[ notify-view view-name ] [ acl acl-number ] *
•
SNMPv1/v2c user:
snmp-agent usm-user { v1 | v2c } user-name group-name
[ acl acl-number ] *
•
SNMPv3 user:
snmp-agent usm-user v3 user-name group-name [ remote
ip-address ] [ { cipher | simple } authentication-mode { md5
| sha } auth-password [ privacy-mode { aes128 | des56 }
priv-password ] ] [ acl acl-number ] *
Figure 16 to allow Host A and Host B to access the device through SNMP.
40
Remarks
For more
information about
SNMP, see
Network
Management and
Monitoring
Configuration
Guide.