Saving The Output From A Display Command To A File - HP FlexFabric 7900 Series Configuration Manual

Characters
\
For example:
# Use | begin line in the display current-configuration command to match the first line of output that
contains line to the last line of output.
<Sysname> display current-configuration | begin line
line class aux
user-role network-admin
#
line class vty
user-role network-operator
#
line aux 1
user-role network-admin
#
line vty 0 63
authentication-mode scheme
user-role network-operator
#
ssh server enable
#
return
# Use | exclude Direct in the display ip routing-table command to filter out direct routes and display only
the non-direct routes.
<Sysname> display ip routing-table | exclude Direct
Destinations : 12
Destination/Mask
2.2.2.0/24
# Use | include snmp in the display current-configuration command to filter in entries that contain snmp.
<Sysname> display current-configuration | include snmp
snmp-agent
snmp-agent community write private
snmp-agent community read public
snmp-agent sys-info version all
snmp-agent target-host trap address udp-domain 192.168.1.26 params securityname public

Saving the output from a display command to a file

A display command shows certain configuration and operation information of the device. Its output
might vary over time or with user configuration or operation. You can save the output to a file for future
retrieval or troubleshooting.
Meaning
Escape character. If a special
character listed in this table follows \,
the specific meaning of the character is
removed.
Routes : 12
Proto Pre Cost
OSPF 10 2
Examples
"\\" matches a string containing "\", "\^"
matches a string containing "^", and "\\b"
matches a string containing "\b".
NextHop
1.1.2.2
12
Interface
FGE1/0/2