Table of Contents
Advertisement
5. If you want JBS-600 change to pair with another Bluetooth Enable Device.
Press and hold the
will flash, the voice "PAIRING" will be heard to confirm the unit will go into
Pairing/Discoverable mode again. Repeat steps 1 and 2.
PLAYING FROM A BLUETOOTH DEVICE
You can play music from your Bluetooth device wirelessly to JBS-600 after
successfully pairing.
1. Selecting your favorite song, press the PLAY button on your Bluetooth device
or the
button (#12) on JBS-600 to play or pause the Bluetooth device
playback.
2. Slowly adjust both the VOLUME Control (#10) of your JBS-600 and your
Bluetooth device until you reach a comfortable listening level.
Notes:
1. Your Bluetooth enabled device will not play the music through the speaker,
even if connected (linked), if the device does not support the A2DP Bluetooth
profile.
2. Remember to turn off the JBS-600 when you have finished listening.
3. Don't forget to switch off the power of your external audio device as well.
You can play other music sources (iPod, MP3 or other digital audio players)
through the speakers of the JBS-600 by connecting the AUX IN Jack (#20) to your
external player's audio out jack or headphone jack.
1. Plug one end of an audio cable (not included) into the AUX IN Jack (#20) and the
other end of the cable to the headphone jack of your digital audio player.
2. Tap then rotate the SOURCE Control (#5) to select AUX mode.
3. Start playing the device you plugged into the AUX IN Jack (#20).
4. Slowly adjust both the volume controls of the JBS-600 and the external device
until you reach a comfortable listening level.
5. Remember to turn off the JBS-600 when you have finished listening.
6. Don't forget to switch off the power of your external audio device as well .
Note :
•
If you connect JBS-600 to the Line-Out Jack of your external device, you only
need to adjust the volume of the JBS-600. If you connect to the Headphone
Jack of your external device, you may need to adjust both the volume controls
of your external device and the JBS-600 to obtain the desirable listening level.
Remember to turn off the JBS-600 when you have finished listening. Don't
•
forget to switch off the power of your external audio device as well.
(#12) for about 4~5 seconds. The "BT" on the display
AUX IN operation
E-14
Advertisement
Table of Contents
