Table of Contents
Advertisement
8.
Rotate the SOURCE Control (#5) to set the wake sound level.
9.
Press the ALARM Button (#6) again to confirm, the alarm time "12:00" will
appear on the display and the Hour digits of alarm time will start flashing.
10.
Rotate the SOURCE Control to set the hour.
11.
Press the ALARM Button again to confirm, the Minute digits will start flashing.
12.
Rotate the SOURCE Control to set the minutes.
13.
Press the ALARM Button again to confirm and complete the alarm setup.
Notes :
• If "Wake to CD" is selected but a CD is not inserted, the alarm will default to
the buzzer alarm "BUZZ" automatically when the alarm wake time is reached.
• For 'Wake to Radio", the system will default to the last radio station listened to
before turning the unit off.
• The alarm will sound for 60 minutes at the time you entered if not turned off.
• When one of the alarms is sounding, the other one is disabled.
• When the set alarm time is ON, the unit will wake you everyday unless you turn
the alarm off.
• To stop the alarm immediately after it sounds, press the STANDBY Button (#10)
on main unit.
SNOOZE
Press the SNOOZE/SLEEP button (#1) for a few more minutes sleep. The alarm
will stop for approximately 9 minutes and then turn on again.
NOTE : THIS UNIT NOT ONLY PLAYS COMMERCIAL COMPACT DISCS BUT
ALSO SELF-COMPLIED CD-RW DISCS.
PLEASE READ THIS IMPORTANT INFORMATION:
CD mechanisms used in devices like this are designed to fully read all commercial
CDs. They will also read self-compiled CD-RWs but it may take up to 10 seconds
for playback to start. If playback does not start, it is likely due to the quality of the
CD-R/RW disc and/or the compatibility of the CD compilation software.
Manufacturer is not responsible for the playback quality of CD-R/RW discs.
Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a
malfunction.
PLAYING A CD
• Press the STANDBY Button (#10) on main unit or remote control to turn on the
unit.
• Rotate the SOURCE Control (#5) on main unit or press the Source Button on
the remote control to select CD mode. The CD icon will turn on.
• Insert an audio CD into the slot located on the front of the unit below the display.
Make sure the CD is inserted with the printed side up.
CD OPERATION
E-11
Advertisement
Table of Contents
