Table of Contents
Related Manuals for Jensen JMC-1100
Summary of Contents for Jensen JMC-1100
- Page 1 3-SPEED STEREO TURNTABLE 3 CD CHANGER MUSIC SYSTEM WITH DUAL CASSETTE DECK AND REMOTE CONTROL OWNER’S MANUAL JMC-1100 PLEASE READ THIS OPERATING MANUAL COMPLETELY BEFORE OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE.
-
Page 2: Dear Jensen® Customer
The serial number of this product is found on its back cover. You should note the serial number of this unit in the space provided as a permanent record of your purchase to aid in identification in the event of theft of loss. Model Number: JMC-1100 Serial Number: ____________________... -
Page 3: Important Safety Instructions
WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. IMPORTANT SAFETY INSTRUCTIONS Read these instructions - All the safety and operating instructions should be read before the appliance is operated... - Page 4 13. Unplug this apparatus during lightning storms or when unused for a long periods of time. 14. Power Sources - The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. Do not overload wall outlet.
- Page 5 CAUTION TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT. FULLY INSERT THE PLUG TO MAIN POWER SOCKET. CAUTION Note: This product complies with DHHS Rule 21 Subchapter J at date of manufacture. Follow the advice below for safe and appropriate operation. ON PROTECTION AGAINST LASER ENERGY EXPOSURE o As the laser beam used in this compact disc player is harmful to the eyes, do not attempt to disassemble the casing.
-
Page 6: Important Notes
ON CONDENSATION • When left in a heated room where it is warm and damp, water droplets or condensation may form inside the unit. • When there is condensation inside the unit, the unit may not function normally. Let it stand for 1 to 2 hours before turning the power on, or gradually heat the room up and dry the unit before use. -
Page 7: Compliance With Fcc Regulations
COMPLIANCE WITH FCC REGULATIONS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation. -
Page 8: Getting Start
GETTING START SPEAKER CONNECTION 1. Insert the speaker cable ends (exposed wires) into the terminals located on the back of the main unit by pushing down the lever of the left speaker terminal and then the right speaker terminal 2. Connect the left speaker to the left speaker terminal with the red wire to L+ and the black wire to L -. -
Page 9: Location Of Controls And Indicators
LOCATION OF CONTROLS AND INDICATORS FRONT VIEW & BACK VIEW 1) LCD DISPLAY 14) DISC 1, 2, 3 SELECTOR 2) REMOTE SENSOR 15) CD DOOR 3) STANDBY LED INDICATOR 16) PRE-SET EQ BUTTON 4) POWER BUTTON 17) CD STOP BUTTON 5) MUTE BUTTON 18) CD PLAY / PAUSE BUTTON 6) FM MODE / DUBBING SPEED SELECTOR... -
Page 10: Remote Control
REMOTE CONTROL OPEN/CLOSE PRESS TO OPEN / CLOSE THE CD DOOR POWER TURNS THE UNIT POWER ON / STANDBY DISC 1,2,3 PRESS TO SELECT THE DISC FOR PLAYBACK DIRECTLY DISC-CH PRESS TO SELECT THE NEXT DESIRE DISC AND ROTATE THE DISC TRAY SLEEP PRESS AND HOLD TO ACTIVE SLEEP FUNCTION TIMER... -
Page 11: Battery Installation
BATTERY INSTALLATION The battery compartment is located on the back of the remote control. Remove the battery compartment door by pressing in on the tab and lifting it off. Insert two (2) AAA size batteries (not included) into the battery compartment as the polarity markings inside the battery compartment. -
Page 12: Setting The Clock
OPERATING INSTRUCTIONS SETTING THE CLOCK 1. Make sure the unit is in STANDBY mode. 2. Press the “MEM/CLK-ADJ” button, the first two digits of the time (hours) “00” are flashing. Press “SKIP DOWN or UP ” button to set the correct hour. Press “MEM/CLK-ADJ” button to store the correct hour. - Page 13 FM & FM-Stereo reception Set the FM mode selector at “MONO” position. Programs are received in mono mode. This is helpful if you are listening to a weak FM station. Set the FM mode selector at “ST” position for receiving stereo programs. The “ST” indicator will appear on LCD to show fm stereo program is being received.
-
Page 14: Repeat Play
2. You can also press either the “ DISC 1”, “ DISC 2 ”, “ DISC 3 ” buttons to start playing a specific disc in the tray. 3. To interrupt, press the “ PLAY/PAUSE ” button once, and the display will start flashing. Press again to resume playback. - Page 15 CD PROGRAMMING Up to 60 tacks can be programmed to be played in any required order from one CD or all CDs in the CD changer. 1. Set in CD mode and press the “STOP ” button. 2. Press the MEM/CLK-ADJ button 3.
-
Page 16: Recording From Cd
A. RECORDING FROM TAPE (DECK B TO DECK A) This unit enables you to duplicate a pre-recorded tape to another tape. It is performed only one way from deck B (playback) to deck A (recording). DUBBING AT NORMAL SPEED Press the “ TAPE ” function button. Inset a pre-recorded cassette into deck B and a blank cassette tape into deck A. - Page 17 D. RECORDING FROM PHONO Press the “PHONO” function button. Place a record onto turntable and insert a blank cassette tape into deck A. Press the “ PAUSE ” key and then press the “ RECORD ” and “ PLAY ” key at deck A. Place tone arm to start playback the record and then release “...
-
Page 18: Mute Function
C. PRESET EQ FUNCTION This unit provides 5 differences sound modes to enhance your listening experience. You can select the desired effect by pressing the “EQ” button repeatedly to get the effect you want:- FLAT JAZZ ROCK CLASSIC D. EXTRA BASS FUNCTION Press down the “Xbass”... -
Page 19: Care And Maintenance
CARE AND MAINTENANCE 1. Do not subject the unit to excessive force, shock, dust or extreme temperature. 2. Do not tamper the internal components of the unit. 3. Clean your unit with a dry cloth. Solvent or detergent should never be used. 4. -
Page 20: Head Cleaning
HEAD CLEANING The tape heads, pinch roller and capstan require periodic cleaning. This removes particles of the metal oxide coating that wear off the tape and accumulate on these parts and impair performance. Switch off the power, press the Stop/Eject key to open the cassette door, and press the Play key. -
Page 21: Compact Disc Care
COMPACT DISC CARE Handle the disc only by its edges. Never allow your fingers to come in contact with the shiny, unprinted side of the disc. Do not attach adhesive tape, stickers etc., to the disc label. Clean the disc periodically with soft, lint-free, dry cloth. Never use detergents or adhesive cleaners to clean the disc. -
Page 22: Troubleshooting Guide
TROUBLE SHOOTING GUIDE PROBLEM POSSIBLE CAUSE SOLUTION The unit is disconnected from the Reconnect to the AC outlet. The unit does not AC outlet respond (no Plug another device into the same power) AC outlet is not functioning. outlet to confirm the outlet is working. -
Page 23: Specification
SPECIFICATION Power Requirement Main unit: AC120V~ 60Hz Remote control 2 x 1.5V “AAA” (UM-4) size batteries (not included) Frequency Range Radio Band FM 87.5 ~ 108 MHz AM 520 ~ 1710 KHz Power Consumption Main Unit: 35Watts At Spectra, environmental and social responsibility is a core value of our business. - Page 24 90 DAY LIMITED WARRANTY AND SERVICE VALID IN THE U.S.A ONLY SPECTRA MERCHANDISING INTERNATIONAL, INC. warrants this unit to be free from defective materials or factory workmanship for a period of 90 days from the date of original customer purchase and provided the product is utilized within the U.S.A.