Table of Contents
Advertisement
This unit comes with an external AM loop antenna that should be connected prior
to using the AM radio. Insert the 2 wires coming from the AM antenna to the AM
Antenna Connector (#19) located on the back of the unit. Press on the 2 levers
located under the connector and insert the one wire into each opening. Reposition
the AM antenna for the best reception.
1.
Tap the STANDBY Button (#10) on main unit or remote control to turn the unit
ON.
2. Tap then Rotate the Source Control on main unit, or tap the Source button on
remote control repeatedly to select FM/AM mode. The FM/AM radio frequency
appears on the display. After 5-10 seconds the display will switch to the current
time. Press the Time Button (#7) to view the current station frequency. The
display will automatically switch back to the current time after 5-10 seconds.
3.
To manually tune to a specific radio station, rotate the Tuning Control (#5) on
main unit to a specific radio station frequency. Use the manual tuning
method to tune in weaker stations that are skipped during Automatic Tuning.
4. Lightly press and hold your finger on the
the unit for over 2 seconds, and the JBS-600 will tune to previous or next
available station.
Storing Preset Radio Stations:
This unit allows you to store up to
access at any time.
1.
Tap the STANDBY Button (#10) on main unit or remote control to turn on the
unit.
2. Tap then Rotate the Source Control on main unit or the Source button on
remote control repeatedly to select FM/AM
3.
Tune to the desired radio station either "manually" or using the AUTO SEARCH
tuning method.
4. Lightly press and hold your finger on the
located on the top of the unit for over 2 seconds,
memory number will be shown flashing on display (Note:"P01" will blink in
the display if you are programming preset for first time).
5.
Rotate the Source Control (#5) to the desired memory number (for example
P01/P02M).
6.
Press the Source Control (#5) to confirm and store the location.
7.
Repeat above steps 3 - 6 to preset up to 40 FM and 40 AM stations.
Hints
This unit features an AUTO SEARCH function that will automatically save the first
40 strong stations found. To use this feature, make sure the unit is in Radio mode,
and select the FM or AM band. Touch the Auto Scan (#15) button located on the top
of the unit , and the unit will scan from the lowest frequency to the highest frequency
within the selected frequency band. The first strong radio stations found will be
stored in the preset locations starting from P01.
RADIO OPERATION
(#16) or
40 FM
stations and 40 AM stations for easy
mode.
PROGRAM SET Button (#14)
E-9
(#17) located on the top of
the next available preset
Advertisement
Table of Contents
