Emerson MVME7616E Installation And Use Manual page 24

Hardware Preparation and Installation
8. Attach the 64-conductor cable (furnished with the MVME761-0x1) to the P2 adapter
(J3 on the 3-row version, J4 on the 5-row version). Be sure to orient cable pin 1 with
connector pin 1.
9. Attach the 64-conductor cable to connector P2 on the transition module. Be sure to
orient cable pin 1 with connector pin 1.
10.Insert the transition module into the chassis slot, and tighten the attaching screws.
Make sure there is good contact with the transverse mounting rails in order to
minimize RF emissions.
11.Install the chassis cover, making sure that cables are not pinched by the cover.
12.Connect the power cable to the AC power source.
24
Installing the Transition Module and P2 Adapter
MVME7616E Transition Module Installation and Use (6806800A43B)