Securing Your Child - R82 Wallaroo User Manual

Once the child restraint has been installed in
the vehicle, follow these instructions to secure
your child in the child restraint
IMPORTANT: Before securing your child in
the child restraint, always check the adjuster
area for debris (e.g., food, coins, toys, etc.).
If debris is present, it must be removed
to prevent interference with the adjuster
mechanism.
1.
Loosen the harness by lifting the adjuster
lever located in front of the child restraint,
then pull the shoulder straps forward (Fig.
A).
2.
Open the chest clip by squeezing the
middle tabs, while pulling the two pieces
apart.
3.
Unfasten the buckle by pressing down on
the middle button.
4.
Move the harness straps to the side of the
child restraint. To aid in holding the straps,
insert the pieces of the chest clip into the
harness retainers on the cover.
5.
Place the child in the child restraint.
6.
Position the harness straps around the
child and fasten the child restraint buckle
(Fig. B). Proper connection is confirmed
with a positive click after inserting the
second buckle tongue.
7.
Gently pull up on the harness straps to
tighten the lap section of the harness,
which should fit low on your child's body.
8.
Fasten the chest clip by connecting the
two halves together (Fig. C).
9.
Slowly pull the adjuster strap to tighten
the harness around the child (Fig. D). The
correct height for the chest clip is at the
middle of the chest, level with the child's
armpit (Fig. E).
continues on next page
support.R82.org

SECURING YOUR CHILD

.
D
A
B
C
E
24