Using The Latch - R82 Wallaroo User Manual

WARNING!
Always use the tether. Using the tether will improve the stability of your
child restraint and reduce the risk of injury.
Attach the tether only to tether anchors designated by your vehicle
manufacturer as tether anchorage points. Use of other locations is not
approved or permitted.
Do NOT modify the vehicle without advice from the vehicle manufacturer if
a tether anchor is not available.
Do NOT hook the tether to the bottom of the vehicle seat adjuster.
IMPORTANT: If your vehicle does not currently have a tether anchor
attachment, reference your vehicle owner's manual or contact your vehicle
manufacturer for assistance.
Using the Top Tether
Consult your vehicle owner's manual for approved tether anchorage
locations.
Locate the tether on the back of the child restraint. Place the tether
components up and over the child restraint back.
Install the child restraint using the LATCH system or the vehicle seat belts
according to the instructions in this manual.
Lift the tether adjuster tab to release the tether straps, and then pull to fully
extend the tether into a "V" shape.
Locate the hooks on the strap.
Attach the tether hooks to tether anchor(s) in vehicle (Fig. A).
See Configuration for proper attachment.
WARNING! Never attach more than one tether hook to a single tether
anchor.
Pull the tether adjuster belt to remove all slack and ensure any excess
tether strap webbing is stored within your vehicle.
Verify that there is no slack in the tether
strap and that the child restraint is properly
secured.
NOTE: The child restraint is secure when it
cannot be moved front-to-back or side-to-side
more than 1 inch (2.5 cm) at the belt path.

USING THE LATCH

A
18
support.R82.org