Installation For Children 22-40 Lbs. (10-18 Kg); Lap Belt - Short Route - R82 Wallaroo User Manual

INSTALLATION FOR CHILDREN 22-40 lbs. (10-18 kg)

Lap Belt - Short Route

You must always use the top tether hook when
installing this child restraint. Loosen the tether
strap and place it up and over the child restraint
back (A).
Installation
Place the child restraint in the forward-facing
position on the vehicle seat. Ensure the bottom
of the child restraint shell is in full contact with
the vehicle seat.
Pull the vehicle belt out and route through the
belt slot furthest from the vehicle buckle (B),
from the rear to the front of the child restraint.
Route the vehicle belt under the child restraint
cover, between the comfort foam and the child
restraint shell, then through the belt slot closest
to the vehicle buckle from front to rear of the
child restraint (C).
Verify that the vehicle belt is not twisted and
then buckle.
Push the child restraint firmly into the vehicle
seat while removing slack from the vehicle belt.
support.R82.org
Lock the vehicle belt according to the
instructions in your vehicle owner's manual.
Attach the tether hook to the vehicle designated
tether anchor for the chosen seating position
to secure (D). Remove all slack from the tether
to secure (E). Store any excess tether strap
webbing within your vehicle.
Verify that all connections are secure, the
vehicle belt is tight, and the child restraint is
secure.
NOTE: The child restraint is secure when it
cannot be moved more than 1 inch (2.5 cm)
front-to-back or side-to-side at the belt path.
If the child restraint is not secure, repeat this
procedure or use an alternate seating position.
C
E
D
B
11
A